Blow molding machine lamp 1000W

Sun, 07 Jun 2026 02:46:28 +0800

On the blow molder, a tired lamp doesn’t just throttle the line—it throws preform heating off, and that shows up fast as PET wall thickness swings, stress lines, and bottles that never make it out of QC. When the OEM lamp price starts to feel like a toll on uptime, you want a drop-in that behaves like the original, without the original’s markup. What matters under the hood We built this 1000W infrared lamp for the heating tunnel on blow molders, hitting the OEM specs that actually matter: stable 1000W output, quick thermal response, and predictable spectral behavior for PET. The halogen-free infrared emitter spreads heat evenly across the preform, so the temperature profile stays repeatable, cycle after cycle. It uses standard R7s connectors and standard mounting dimensions, so it goes in where the old lamp lived—no bracket fabrication, no rewiring. Why it holds up on real machines If you’re running Sidel, Krones, SIPA, Husky, SACMI, or Nissei ASB, you need the heating system to behave the same shift after shift. This lamp matches the OEM in power and response, so preform conditioning stays within spec, and blow-up consistency tightens up. The payoff is straightforward: fewer rejects, less scrap, and fewer tiny stops to chase lamp-related drift. And because we supply it direct with OEM-level manufacturing controls, you get the reliability you’re used to at a price that doesn’t need committee approval. A few shop-floor notes It’s a direct swap, but confirm your machine’s voltage and socket type before ordering. These lamps run hot, so keep the reflectors clean and make sure airflow in the heating zone stays as designed—overheating the lamp or reflector will cut life short. For maximum lifespan, match the lamp to the original cycle rate and don’t push the heating zone hotter than necessary.

1000W on Warm IR Corner Heating

Blow molding machine lamp 1000W